Removing And Reinstalling The S7-1200 Terminal Block Connector - Siemens S7-1200 System Manual
Hide thumbs
Also See for S7-1200:
- Operating instructions manual (132 pages) ,
- Programming manualline (74 pages) ,
- Manual (46 pages)
Table of Contents
NOTICE
Separate modules without using a tool.
Do not use a tool to separate the modules because this can damage the units.
3.3.6
Removing and reinstalling the S7-1200 terminal block connector
The CPU, SB and SM modules provide removable connectors to make connecting the wiring
easy.
Table 3- 10
Removing the connector
Task
S7-1200 Programmable controller
System Manual, 03/2014, A5E02486680-AG
Procedure
Prepare the system for terminal block connector removal by removing the power from the
CPU and opening the cover above the connector.
1. Ensure that the CPU and all S7-1200 equipment are disconnected from electrical power.
2. Inspect the top of the connector and locate the slot for the tip of the screwdriver.
3. Insert a screwdriver into the slot.
4. Gently pry the top of the connector away from the CPU. The connector will release with a
snap.
5. Grasp the connector and remove it from the CPU.
3.3 Installation and removal procedures
Installation
63
Table of Contents
