Configuring Ripng Ipsec Policies - HP 3600 v2 series Configuration Manual
Hide thumbs
Also See for 3600 v2 series:
- Command reference manual (510 pages) ,
- Configuration manual (449 pages) ,
- Security configuration manual (398 pages)
Table of Contents
NextHop
Interface
Destination: 1::/64
NextHop
Interface
Destination: 1::1/128
NextHop
Interface
Destination: 2::/64
NextHop
Interface
Destination: 2::1/128
NextHop
Interface
Destination: 4::/64
NextHop
Interface
Destination: FE80::/10
NextHop
Interface
Configuring RIPng IPsec policies
Network requirements
In the following figure, configure RIPng on the switches, and configure IPsec policies on the switches to
authenticate and encrypt protocol packets.
Figure 105 Network diagram
Configuration procedure
Configure IPv6 addresses for interfaces. (Details not shown)
1.
Configure RIPng basic functions
2.
# Configure Switch A.
[SwitchA] ripng 1
[SwitchA-ripng-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ripng 1 enable
: ::1
: InLoop0
: 1::1
: Vlan100
: ::1
: InLoop0
: 2::1
: Vlan200
: ::1
: InLoop0
: FE80::200:BFF:FE01:1C02
: Vlan100
: ::
: NULL0
277
Preference: 0
Cost
: 0
Protocol
: Direct
Preference: 0
Cost
: 0
Protocol
: Direct
Preference: 0
Cost
: 0
Protocol
: Direct
Preference: 0
Cost
: 0
Protocol
: Direct
Preference: 0
Cost
: 0
Protocol
: RIPng
Preference: 100
Cost
: 4
Protocol
: Direct
Preference: 0
Cost
: 0d
- Quick Links:
- Ip Routing Basics
Hide quick links:
Table of Contents
Troubleshooting
