Layer 3 Aggregation Load Sharing Configuration Example - HP 6600 Configuration Manual
Hide thumbs
Also See for 6600:
- Security configuration manual (559 pages) ,
- Command reference manual (286 pages) ,
- Installation and getting started manual (103 pages)
Table of Contents
# Assign Layer 3 Ethernet interfaces GigabitEthernet 4/0/1 through GigabitEthernet 4/0/3 to
aggregation group 1.
[RouterA] interface GigabitEthernet 4/0/1
[RouterA-GigabitEthernet4/0/1] port link-aggregation group 1
[RouterA-GigabitEthernet4/0/1] quit
[RouterA] interface GigabitEthernet 4/0/2
[RouterA-GigabitEthernet4/0/2] port link-aggregation group 1
[RouterA-GigabitEthernet4/0/2] quit
[RouterA] interface GigabitEthernet 4/0/3
[RouterA-GigabitEthernet4/0/3] port link-aggregation group 1
[RouterA-GigabitEthernet4/0/3] quit
# Configure Router A to use the source and destination IP addresses of packets as the global
link-aggregation load-sharing criteria.
[RouterA] link-aggregation load-sharing mode source-ip destination-ip
2.
Configure Router B in the same way Router A is configured. (Details not shown.)
3.
Verify the configuration:
# Display summary information about all aggregation groups on Router A.
[RouterA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG
Interface
-------------------------------------------------------------------------------
RAGG1
The output shows that link aggregation group 1 is a load-shared Layer 3 dynamic aggregation
group and it contains three Selected ports.
# Display the global link-aggregation load-sharing criteria on Router A.
[RouterA] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-ip address,
The output shows that the global link-aggregation load-sharing criteria are the source and
destination IP addresses of packets.
Layer 3 aggregation load sharing configuration example
Network requirements
Configure two Layer 3 static aggregation groups (1 and 2) on Router A and Router B in
configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.
Configure link aggregation group 1 to perform load sharing based on source IP address and link
aggregation group 2 to perform load sharing based on destination IP address.
AGG
Partner ID
Mode
D
0x8000, 000f-e2ff-0002
source-ip address
Select Unselect
Ports
3
36
Share
Ports
Type
0
Shar
Figure 1
1, and
Table of Contents
