Table of Contents
[ V Remote Controller ]
V Remote Controller
[1] Functions and Specifications of MA Remote Controller
1. Functions/Specifications
Functions/Specifications
Remote controller address setting
indoor-outdoor unit address setting Required
Wiring method
Remote controller installation posi-
tion
Grouping change
*1. MA remote controller refers to MA remote controller (PAR-21MAA).
[2] Using the built-in Temperature Sensor on the Remote Controller
1. Selecting the position of temperature detection (Factory setting: SW1-1 on the controller board on the indoor unit is
set to OFF.)
To use the built-in sensor on the remote controller, set the SW1-1 on the controller board on the indoor unit to ON.
Some models of remote controllers are not equipped with a built-in temperature sensor. Use the built-in temperature sensor
on the indoor unit instead.
When using the built-in sensor on the remote controller, install the remote controller where room temperature can be detected.
HWE10190
Not required
Non-polarized two-wire
∗To perform a group operation, daisy-chain the indoor units using non-polarized two-
wire cables.
Attached to the unit body
MA remote controller wiring between indoor units requires rewiring.
- 63 -
*1
MA remote controller
GB
Hide quick links:
Table of Contents
Troubleshooting
