Table of Contents
MAINTENANCE
Wheel Installation
1. Verify the transmission is still in PARK.
2. Place the wheel in the correct position on the wheel
hub
. Be sure the valve stem
outside and rotation arrows on the tire point toward
forward rotation.
3. Attach the wheel nuts
4. Carefully lower the vehicle to the ground.
5. Torque the wheel nuts and/or hub nut
proper torque specification (see Chapter 2 – Wheel
and Hub Torque Table, page 2.31).
6. If hub nut was removed, install a new cotter pin
after the hub nut has been tightened. If the holes do
not line up, turn the hub nut counter-clockwise until
the cotter pin can be installed.
CAUTION
If wheels are improperly installed it could affect vehicle
handling and tire wear. On vehicles with tapered wheel
nuts, make sure tapered end of nut goes into taper on
wheel.
2.32
is toward the
and finger tighten them.
1
to the
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
© Copyright 2014 Polaris Industries Inc.
Tire Inspection
• Improper
tire
inflation
maneuverability.
• When replacing a tire always use original
equipment size and type.
• The use of non-standard size or type tires may
affect vehicle handling.
WARNING
Operating with worn tires will increase the possibility of
the vehicle skidding easily with possible loss of control.
Worn tires can cause an accident.
Always replace tires when the usable tread depth has
worn out.
Tire Pressure
Remove the valve stem cap and check tire pressure
using the tire pressure gauge included in the vehicle's
tool kit.
CAUTION
Maintain proper tire pressure.
Refer to the warning tire pressure decal
applied to the vehicle.
TIRE PRESSURE INSPECTION (COLD)
Model
Front
16 psi (110 kPa)
XP
19 psi (131 kPa)
XP4
High Lifter
18 psi (124 kPa)
may
affect
vehicle
Rear
16 psi (110 kPa)
21 psi (145 kPa)
18 psi (124 kPa)
Chapters
Table of Contents
Troubleshooting
