General Vehicle Inspection And Maintenance; Pre-Ride / Daily Inspection; Shift Cable Inspection / Adjustment - Polaris RZR XP 1000 Service Manual

Hide thumbs Also See for RZR XP 1000:
Table of Contents
MAINTENANCE

GENERAL VEHICLE INSPECTION AND MAINTENANCE

Pre-Ride / Daily Inspection

Perform the following pre-ride inspection daily, and when
servicing the vehicle at each scheduled maintenance.
• Engine Oil - Check for proper level on dipstick (see
Chapter 2 – Engine Oil Level, page 2.17)
• Tires - check condition and pressures
• Fuel tank - fill to proper level
• All brakes - check operation and fluid level and
adjustment (includes parking brake on INT'L
Model)
• Headlights/Taillights/Brakelights
operation of all indicator lights, instrument cluster
and switches
• Ignition switch - check for proper function
• Wheels - check for tightness of wheel nuts and
axle nuts; check to be sure axle nuts are secured
by cotter pins
• Engine Intake Pre-Filter - Inspect pre-filter and
clean with soapy water and low pressure
compressed air if necessary
• PVT Intake Pre-Filter - Inspect pre-filter and clean
with soapy water and low pressure compressed air
if necessary
• Steering - check for free operation noting any
unusual looseness in any area
• Loose parts - visually inspect vehicle for any
damaged or loose nuts, bolts or fasteners
• Engine coolant - check for proper level at the
recovery bottle
• Drive Shaft Boots - Inspect inner and outer boots
for tears or damage on both front and rear drive
shafts
• Check all front and rear suspension components
for wear or damage.
2.10
-
also
check
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
© Copyright 2014 Polaris Industries Inc.

Shift Cable Inspection / Adjustment

Shift cable adjustment may be necessary if symptoms
include:
• No gear position or AWD display on instrument
cluster
• Ratcheting noise on deceleration
• Inability to engage into a gear
• Excessive gear lash (noise)
• Gear selector moving out of desired range
1. Locate the shift cable
case in the right rear wheel well area.
2. Inspect shift cable, clevis pin, pivot bushings
dust boot
. Replace if worn or damaged.
3. If adjustment is required, loosen the lower jam nut
and pull the cable out of the mount
upper jam nut
.
4. Adjust the shift cable so there is the same amount of
cable travel when shifting slightly past HIGH gear
and PARK.
attached to the transmission
1
, and
to move the
Table of Contents
loading

This manual is also suitable for:

Rzr xp4 1000

Table of Contents