Table of Contents
ENGINE / COOLING SYSTEM
ENGINE DISASSEMBLY / INSPECTION - LOWER END
Stator Cover Removal / Inspection
NOTE: The stator cover can be removed with the
engine installed in the chassis.
1. Remove the thirteen screws retaining the stator
cover.
CAUTION
The flywheel contains powerful magnets. Use caution
when removing and installing the stator cover. DO NOT
place fingers between cover and crankcase at any time
during the removal / installation process or injury could
3.44
result.
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
© Copyright 2014 Polaris Industries Inc.
2. Carefully pry the stator cover off the engine using the
two pry areas as shown.
3. Inspect the condition of the stator windings
output wires
. If replacement is required, refer to
Chapter 10.
and
1
Chapters
Table of Contents
Troubleshooting
