1. Manuals
  2. Brands
  3. Hitachi Manuals
  4. Saw
  5. C 10FCB
  6. Handling instructions manual

Hitachi C 10FCB Handling Instructions Manual

Compound saw
Hide thumbs Also See for C 10FCB:
1
2
3
4
5
6
7
8
Table of Contents

Quick Links

See also: Instruction Manual, Handling Instructions Manual
COMPOUND SAW
MODEL C 10FCB

HANDLING INSTRUCTIONS

NOTE:
Before using this Power Tool, carefully read through these HANDLING
INSTRUCTIONS to ensure efficient, safe operation. It is recommended that
these INSTRUCTIONS be kept readily available as an important reference
when using this power tool.
Table of Contents
loading

Related Manuals for Hitachi C 10FCB

Summary of Contents for Hitachi C 10FCB

  • Page 1: Handling Instructions

    COMPOUND SAW MODEL C 10FCB HANDLING INSTRUCTIONS NOTE: Before using this Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this power tool.

  • Page 2: General Operational Precautions

    HITACHI catalog may present a risk of personal Do not force the tool. It will do the job better and injury.

  • Page 3: Specifications

    Do not use saw blades which are damaged or 15. Start cutting only after motor revolution reaches deformed. maximum speed. Use only saw blades recommended by HITACHI. 16. Promptly cut OFF the switch when abnormality Select saw blades in relation to the material to be observed.

  • Page 4: Adjusting The Power Tool Prior To Use

    (1) Loosen the 8 mm lock nut on the 8 mm depth adjustment bolt. (2) Turn the 8 mm depth adjustment bolt as necessary to Gear Case set the lower limit position. The saw blade goes up when the 8 mm depth adjustment bolt is turned Locking Pin counterclockwise and down when it is turned clockwise.
  • Page 5 (3) Turn the upper knob and securely fix the workpiece NOTE in position. Positive stops are provided at the right and left of the 0° center setting, at 15°, 22.5°, 30°, 45° and 60° Screw Knob right and 15°, 22.5°, 30° and 45° left settings. Holder 6 mm Wing Check that the miter angle scale and the tip of the...
  • Page 6 WARNING 1. Mounting the saw blade (Fig. 9, Fig. 10 and Fig. 11) Always secure the workpiece with the right hand (1) Press in lock lever and loosen bolt with 10 mm box side for compound cutting. wrench. Never rotate the turntable to the right for Since the bolt is left-hand threaded, loosen by turning compound cutting, because the saw blade might it to the right.

  • Page 7: Maintenance And Inspection

    Never attempt to install saw blades larger than 10" (255 mm) in diameter. NOTE Always install saw blades that are 10" (255 mm) Due to HITACHI’s continuing program of research and in diameter or less. development the specifications herein are subject to change without prior notice.
  • Page 8 Hitachi Koki Co., Ltd. Code No. H99322813 Printed in China...

Table of Contents