Quick Links
Wi-Fi Wireless Device
Quick Installation Guide
Homeowner or contractor installation
WARNING:
• Refer to this Quick Installation Guide to install Fujitsu Wi-Fi Wireless Device IS-IR-WIFI-1 only. This guide does NOT replace
any installation manual(s).
• Have contractors refer to the installation manuals that accompany this unit for complete and specific installation details and
requirements.
• The manufacturer shall in no way be responsible for improper installation, start-up, maintenance or service, including issues
caused by failure to follow all appropriate instructions in the installation manuals.
• Carefully read the installation and owner manual(s) before beginning.
• NOTE to Contractors: For technical support, contact your Fujitsu Distributor.
Wireless Device Installation
FJ-IR-WIFI-1NA
Power supply
Possible mounting positions
10 ft +
10 ft
Total=20ft max
D
20 ft max
FJ-IR-WIFI-1NA
Recommended for the following indoor types:
• Wall mounted
• Floor
• Compact Cassettes
20 ft direct
10 ft
+__
10 ft____
Total: 20 ft
To update the App status according to the last
command sent from the Fujitsu wireless
remote controller. Use the following Wi‐Fi
module mounting position illustrated below
when sending signal from the wireless
remote controller.
IR Emitter 1
IR Receiver
IR Emitter 2
4
4
Related Manuals for Fujitsu FJ-IR-WIFI-1NA
Summary of Contents for Fujitsu FJ-IR-WIFI-1NA
-
Page 1: Quick Installation Guide
Homeowner or contractor installation WARNING: • Refer to this Quick Installation Guide to install Fujitsu Wi-Fi Wireless Device IS-IR-WIFI-1 only. This guide does NOT replace any installation manual(s). • Have contractors refer to the installation manuals that accompany this unit for complete and specific installation details and requirements. -
Page 2: Before Starting
Set up Wireless Device FJ-IR-WIFI-1NA You need the following: • IntesisHome Device • Wi‐Fi Device (laptop/smartphone/tablet) • Access Point or Router • Quick Start Guide/ Install manual Before starting 7Ft Max Check Wi‐Fi Signal strength on the Get close to the device placement location. • If you have enough Wi-Fi signal then proceed to install. • If you don’t have enough Wi-Fi signal: a. Try to install the IntesisHome device in other place b. - Page 3 Set up ihconfig.com Go to Set up Select your Wi‐Fi network Insert Password Click Next...
- Page 4 Set up Device will blink in the sequence below: *Note: If the device cannot connect to the router/access point. Please go back to step number one and start again. Once the device is connected to your wireless network. Make an account and register the device on user.intesisHome.com *Note: A confirmation email will be send to you. Follow the instructions before moving to the next step. IR Configuration Once you have the IntesisHome device installed and Wi‐Fi configured, you are ready to start the IR Configuration process. Learning mode is use to provide the end user a quick way to set up their IR wireless connection in seconds. NOTE: Make sure that the AC unit is Off and the Fujitsu wireless Controller is Off before pressing the On/Off button. In order to ensure the learning process, please make sure you send an On command from your Fujitsu Wireless controller. Make sure your wireless remote controller has fully charge batteries. 1) Fujitsu wireless remote controller is off, only time should be display in the remote controller. 2) Press and hold the black button on the back of the Wi‐Fi module for 4 seconds . Top LED will turn on steady white. 3) Press Start Stop on your Fujitsu wireless remote controller while pointing to the Wi‐Fi module. Refer to picture A: • If the IntesisHome device LED starts blinking Green, the IR learning process has been successful. • If the IntesisHome device LED starts blinking in Red, repeat the process from step 1 and check our compatibility list. If problem still persists, please visit our support section at 3ft Max 3ft max www.fujitsugeneral.com/wifi.htm • If the IntesisHome device LED turns Off, repeat the process from step 1 and check that your IR wireless remote controller has batteries and that you are pointing directly to the IntesisHome IR ...
- Page 5 Wireless module LED Definitions WPS: Wi‐Fi Protected Setup.
- Page 6 Multi‐Zone and HFI Applications Applications with multiple indoor units, each indoor unit must have its own Intesis Wi‐Fi module to manage each zone independently through one account. • Room 4 Room 1 Room 2 • Room 1 • Room 3 • Room 2 Room 3 Room 4 Multi‐Zone Application: Steps to Register New (additional) Devices Click 1) In your IntesisHome account click on the settings option 2) Click on Devices Click 4) Fill and verify code. Code is located on the 3) Click on Add a Facility. Fill all information needed then Click on the device or in the products box. Follow the same plus sign procedure if you have more than one module in your installation. Click Click...
- Page 7 Compatibility FJ-IR-WIFI-1NA Warning Use only parts, accessories and controls supplied or specified by Fujitsu. Ask a licensed contractor to install all parts, accessories and controls. Use of unauthorized or improper installation of parts, accessories and controls can result in injury, major equipment repairs or property damage. Read the owner's operation manual carefully before using this product. The owner’s operation manual provides important safety instructions and warnings which should be followed closely. For any questions or concerns, please contact Fujitsu General America, Inc. Non‐Internet Retail Policy Internet sales are strictly prohibited and unauthorized. Any Fujitsu HVAC systems or components purchased on the Internet, from an online retailer or any similar e‐tailing website, OR where the original factory serial numbers of the display have been removed, defaced, or replaced in any way Fujitsu General America, Inc. WILL NOT BE COVERED BY WARRANTY. 353 Route 46 West Fairfield, NJ 07004 Toll Free: (888) 888‐3424 Trademarks Local: (973) 575‐0380 The Fujitsu logo is a registered trademark of Fujitsu Limited. Fax: (973) 836‐0447 The Halcyon logo and name is a trademark of Fujitsu General Email: [email protected] America, Inc. www.fujitsugeneral.com A subsidiary of Copyright © 2015 Fujitsu General America, Inc. Fujitsu General Limited Fujitsu’s products are subject to continuous improvements. Fujitsu reserves the right to modify product design, specifications and information in this guide without notice and without incurring any obligations.