Error Code [6603]; Error Code [6606] - Mitsubishi Electric PUHY-P200 Service Handbook
Hide thumbs
Also See for PUHY-P200:
- Service handbook (355 pages) ,
- Service handbook (182 pages) ,
- Service handbook (40 pages)
Table of Contents
[7-8 Error Code Definitions and Solutions: Codes [6000 - 6999] ]
7-8-6
Error Code [6603]
1. Error code definition
Transmission line bus busy error
2. Error definition and error detection method
Generated error when the command cannot be transmitted for 4-10 minutes in a row due to bus-busy
Generated error when the command cannot be transmitted to the transmission line for 4-10 minutes in a row due to noise
The address/attribute appeared on the display on the remote controller indicates the controller where an error oc-
curred.
3. Cause, check method and remedy
(1)
The transmission processor cannot be transmit-
ted as the short-wavelength voltage like noise ex-
ists consecutively on the transmission line.
(2)
Error source controller failure
7-8-7
Error Code [6606]
1. Error code definition
Communication error between device and transmission processors
2. Error definition and error detection method
Communication error between the main microcomputer on the indoor unit board and the microcomputer for transmission
The address/attribute appeared on the display on the remote controller indicates the controller where an error oc-
curred.
3. Cause, check method and remedy
(1)
Data is not properly transmitted due to accidental
erroneous operation of the controller of the error
source.
(2)
Error source controller failure
HWE14040
Cause
Cause
Check method and remedy
Check the transmission wave shape and noise on the
transmission line.
See the section "Investigation of Transmission Wave
Shape/Noise."
→ No noise indicates that the error source controller is a
failure.
→ If noise exists, investigate the noise.
Check method and remedy
Turn off the power source of the outdoor and the indoor
units.(When the power source is turned off separately, the
microcomputer will not be reset, and the error will not be
corrected.)
→ If the same error occurs, the error source controller is
a failure.
- 209 -
GB
Chapters
Table of Contents
Troubleshooting
