LG LDE3019ST Installation Manual

Hide thumbs Also See for LDE3019ST:
INSTALLATION MANUAL
ELECTRIC DOUBLE
OVEN RANGE
Please read these instructions thoroughly before
installing and operating the range.
LDE3019ST
LDE3015ST
LDE3017ST
LDE3015SB
LDE3017SB
LDE3015SW
LDE3017SW
LDE3011ST
LDE3037ST
LDE3035ST
LDE3037SB
LDE3035SB
LDE3037SW
LDE3035SW
LDE3031ST
www.lg.com
Table of Contents
loading

Summary of Contents for LG LDE3019ST

  • Page 1 INSTALLATION MANUAL ELECTRIC DOUBLE OVEN RANGE Please read these instructions thoroughly before installing and operating the range. LDE3019ST LDE3015ST LDE3037ST LDE3035ST LDE3017ST LDE3015SB LDE3037SB LDE3035SB LDE3017SB LDE3015SW LDE3037SW LDE3035SW LDE3017SW LDE3011ST LDE3031ST www.lg.com...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS TABLE OF CONTENTS SAFETY 3 Before You Begin 3 Important Safety Instructions 5 Prepare to Install the Range PREPARE TO INSTALL RANGE 6 Installation Drawings ELECTRICAL CONNECTIONS 7 Electrical Connection Requirements 7 Connect Range Cord 8 3-Wire Connection With a Power Supply Cord 9 4-Wire Connection With a Power Supply Cord 9 3-Wire Connection: Conduit 10 4-Wire Connection: Conduit...
  • Page 3: Safety

    Remove all tape and packing materials before using the range. Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials. You can download the installation and owner’s manual at: http://www.lg.com. IMPORTANT SAFETY INSTRUCTIONS Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, personal injury, or damage when using the range.
  • Page 4 SAFETY WARNING • Using an extension cord to connect the power is prohibited. The way to connect the power cord and plug directly is strongly recommended. • Electrical ground is required on this appliance. • You should make sure that the power cord is not pinched by the range or heavy objects. - Failure to do so can result in serious burns or electrical shock.
  • Page 5: Prepare To Install The Range

    SAFETY PREPARE TO INSTALL THE RANGE WARNING • The information in this manual should be TOOLS NEEDED followed exactly. - A fire or electrical shock may result causing property damage, personal injury or death. Phillips Screwdriver Level WARNING Flat-blade Adjustable Wrench Tip - Over Hazard Screwdriver A child or adult can tip the range and be...
  • Page 6: Prepare To Install Range

    PREPARE TO INSTALL THE RANGE INSTALLATION DRAWINGS (LDE Series only) NOTE WARNING • You should use two or more people to move and SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR. install range. (Excessive Weight Hazard) - Failure to do so can result in back or other injury. •...
  • Page 7: Electrical Connections

    ELECTRICAL CONNECTIONS ELECTRICAL CONNECTION CONNECT RANGE CORD REQUIREMENTS WARNING This appliance must be installed and grounded on a • You never remove the protection cover covering the rear of lower oven. branch circuit by a qualified technician in accordance - Failure to do so can result in serious damage to power with the National Electrical code ANSI/NFPA NO.
  • Page 8: 3-Wire Connection Witha Power Supply Cord

    ELECTRICAL CONNECTIONS 3-WIRE CONNECTION WITH A POWER SUPPLY CORD WARNING • The middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected to the middle post of the main Cord strain relief terminal block.
  • Page 9: 4-Wire Connection Witha Power Supply Cord

    ELECTRICAL CONNECTIONS 4-WIRE CONNECTION WITH 3-WIRE CONNECTION: CONDUIT A POWER SUPPLY CORD Install the conduit as follows: WARNING Remove the Conduit connection plate from the rear of lower oven and rotate it as shown in Figure 5. The • Only a 4-conductor power-supply cord kit rated conduit hole (1 ”) must be used.
  • Page 10 ELECTRICAL CONNECTIONS 4-WIRE CONNECTION: CONDUIT 1. Follow the instructions under “Install the conduit as 4-wire connection follows” on page 9 to correctly install the strain relief. Black White Red DO NOT install the conduit without a strain relief. Terminal 2. Loosen the 2 lower left and right screws from the block terminal block.
  • Page 11: Install The Range

    INSTALL THE RANGE Replace the access cover on the back of the range. To replace the wire cover, insert the two tabs into the openings located below the opening and tighten the three screws. Lower Access cover range leveler Raise range Use a level to check your adjustments.

Table of Contents