Page 9
Chapter One INTRODUCTION Introduction Identification of Controls Front Panel Rear Panel Remote Control...
Page 10
INTRODUCTION Toshiba HD-C26H Digital High Definition Receiver opens up to a new world of free-to-air terrestrial HDTV (High Definition Television) and SDTV (Standard Definition Television) programs. The receiver can receive channels from both VHF and UHF bands. All the major terrestrial free-to-air station numbers currently available in your area are listed in the on-screen menu.
“RF OUT” Connection to TV or VCR This “RF OUT” provides you a RF loop-through function to receive analogue TV programs as well as digital programs. Use an RF coaxial cable (not supplied) to connect the HD-C26H “RF OUT” terminal to TV’s or VCR’s antenna input.
Page 17
For better video quality, it is recommended that you use the HDMI cable, the Mini D-Sub 15-pin cable or the RGBHV video cable (with 5 RCA connectors). These cables are not included in the HD-C26H package. HD MODE Switch selection is essential for several outputs. Refer to the HD MODE Switch table on page 54 for making the correct switch selection according to your output connection.
Page 18
HD-C26H 726+,%$ To TV Mini D-sub 15-pin video input HD MODE Mini D-sub 15-pin video cable (not supplied ) Note: This diagram illustrates video connections only. Refer to Page 20 for Audio connection. RGBHV (RCA) connection: If your TV has RGBHV video inputs, use a RGBHV video cable (not supplied) to connect the receiver to your TV.
Page 19
If your TV has component video inputs, use the component video cable included in the HD-C26H accessory box. Set the HD MODE Switch (refer to page 54) to YP , and then connect the Y/G, P /B and P /R connectors from “HD VIDEO OUT”...
Page 20
(f) Composite video connection: If your TV has composite video inputs, use the yellow connector of the Audio/Video cable included in the HD-C26H accessory box. Connect the yellow video connector from “SD VIDEO OUT” on the rear of the receiver to the corresponding jack on the TV.
(not supplied) to connect from the receiver’s “DIGITAL AUDIO OUT (Optical/Coaxial)” to the digital audio input of your amplifier. In this case make sure that you DO NOT need to connect the audio connectors (red and white) on the Audio/Video cable to your TV. HD-C26H Amplifier equipped with a Dolby decoder...