Hitachi HV-D30 Setup Manual

The HV-D30 uses a menu system to make changes to the operation and settings of the camera.

Pressing and holding the

the camera in the

SPECIAL SET

In order to get the best performance from the Hitachi HV-D30 when it is used on a microscope, the fol-

lowing settings are recommended.

Activate the MENU system by pressing the MENU button on the rear of the camera. Using the

DOWN arrow key scroll down to the bottom of the screen and make sure that the FILE SELECT is set

to File 1, (any File number can be used except PRESET) Use the RIGHT arrow key to change the

FILE setting. All camera settings made will be saved to the selected FILE and will be retained even

when the camera is powered down. Changes made to the PRESET FILE will not be saved when the

power is removed from the camera.

Using the UP arrow key scroll to the top of the menu and set the CAMERA MODE to MAN-

•

UAL by using the RIGHT arrow key. Scroll down to the WHITE BALANCE mode and

change this setting to AUTO or MEMORY depending on the application. See explanation of

these choices at the end of this page.

Turn off the MENU by pressing the MENU button. Next we need to enter the SPECIAL SET

•

MENU. Hold down the UP arrow and press and hold the MENU button for 2 seconds. The

screen will display the SPECIAL SET MENU. Use the DOWN arrow key to scroll down to the

LENS setting. Change the LENS type to DC. Use the LEFT arrow key to go back to the SPE-

CIAL SET MENU.

HV-D30 Microscope Setup

MENU

camera on screen menu system.

UP

direction.

RIGHT

RIGHT.

LEFT

LEFT.

DOWN

DOWN direction.

UP

button while pressing and holding the

MENU.

Button – Pressing this button turns on or off the

Button – This button moves the cursor in the UP

Button – This button moves the cursor to the

Button – This button moves the cursor to the

Button – This button moves the cursor in the

MENU

1

HITACHI

Hitachi Kokusai Electric America

button for 2 seconds puts